COMPRESS. ASME Section VIII software for Professionals ASME, VIII, Section, software, COMPRESS

thomas

.  http://www.codeware.com/?gclid=CLeijZ-HvpcCFRQNewodtlOQTA

  COMPRESS is the leading software for the design and analysis of ASME Section VIII pressure vessels and heat exchangers.

Since 1985, Codeware has focused exclusively on developing comprehensive software for the most discriminating Engineers. We invite you to see why professionals at over 1,400 companies worldwide rely on COMPRESS.

Download trial software
Learn more about COMPRESS
Go to the Support Center


News and Promotions

December 2, 2008 - Update to COMPRESS released. Download now.
November 7, 2008 - Update to Coster released. Download now.
November 1, 2008 - New website released!
The Part UHX White Paper is now available in the Support Center. Click here to download PDF.
PRG's finite element analysis of nozzles capability is now a standard COMPRESS feature. Learn more.
The COMPRESS 2007 Verification Manual and Build 6256 baseline (verification) files are now available in the Support Center.
New mailing list subscribers will receive Codeware's signature ASME Code book tabbed dividers. Sign up today!
COMPRESS Build 6260 Released (December 2, 2008)

Includes the ASME Section VIII, Division 1 2008 Addenda
Introduces a new "Project" feature which allows users to organize, view and backup files of any type from within COMPRESS
Provides an enhanced rigging analysis diagram
Includes the ability to report the external surface area of a vessel in the Weight Summary report
Makes available a confined gasket flange facing type for Appendix 2 flanges
Includes the ability to specify a raised face diameter and height for applicable Appendix 2 flanges
Provides an option to select the flange type from Appendix 2 Figure 2-4 (1) through (10), excluding (6a) and (6b)
Per the note in Appendix 2-5(e), the full available bolt load AbSa may be used where additional safety against abuse is desired
Includes an option to perform flange rigidity calculations for the MAP condition
Uses the ASME B16.5 2003 metric pressure ratings for standard flanges for SI or MKS units